Microscope Imaging System Stage, Compatible with 95 mm Extrusions IMA95-50Z

JCOPTIX microscopy stages and components provide high load capacity and convenient, reliable mounting. Coarse/fine Z lifts have open dovetails that snap onto 95 mm profiles anywhere. Fine resolution reaches micrometers, with no defocus or stress rebound after adjustment as stated. Microscope stages move smoothly without sticking/jumps and accept different slide holders for varied applications. Coarse/fine Z lift for 95 mm profiles. Model: IMA95-50Z. Maximum load 10 kg; minimum adjustment 1 μm; top M4/M6 holes for expansion; open dovetail mounts anywhere on 95 mm profiles. JCOPTIX lifts have coarse travel 48 mm, coarse resolution 32.4 mm/r, fine travel ±1.5 mm, minimum resolution 1 μm/division, and maximum load 10 kg. A thin handwheel on the right locks the mechanism. The open rear dovetail attaches anywhere on JCOPTIX 95 mm profiles. Evenly distributed M4/M6 top holes mount optomechanics for precise Z adjustment. In an actual stability test with 12kg load and 38.8-times magnification, after focusing and standing for 20 hours the lift dropped less than 2um. Microscope stage. Model: IMA-80XY. Maximum load 2 kg; maximum travel ±80 mm; top M3 holes adapt various slide holders; stable, reliable adapter support. JCOPTIX supplies X/Y stages, adapters, and holders. IMA-80XY has maximum load 2 kg, travel ±80 mm, and a 110 mm × 110 mm central clear aperture for most transmission microscopes. Bottom 4 M4 countersunk holes secure the stage; top M3 holes accept various slide holders sold on the website or custom holders. Contact tech-support@jcoptix.com. Mounting holes fit Thorlabs slide holders. Copper rack-and-pinion drive gives continuous, reliable motion without sticking/jumping. X resolution is 26 mm/r and Y resolution 32.5 mm/r. Microscope-stage adapter. Model: IMA-ZAD4. JCOPTIX IMA-ZAD4 connects IMA95-50Z coarse/fine Z lifts to IMA-80XY stages. Underneath ribs increase strength and load capacity. A central 145 mm × 95 mm aperture suits transmission paths and noncontact sample observation by objectives below. Four-position slide clamp. Model: IMA-SA1713F. 4 slide positions; for upright/inverted microscopes; 3 leveling set screws. JCOPTIX IMA-SA1713F has a 140 mm × 65 mm rectangular opening and four slots above it for 76.5 mm × 26.2 mm slides. The four corners carry 4 captive M3 mounting screws. For applications requiring precise sample leveling, three M4×0.5 threaded set screws adjust level. During installation, ensure set screws do not protrude below the holder and damage the platform or sample. Slide holder with central SM2 through-thread, 60 mm cage compatibility, and clamp plates. Model: IMA-SA1713. Slide clamps on both sides; central SM2 threaded hole; 3 leveling set screws. IMA-SA1713 has a central SM2 threaded hole surrounded by 60 mm cage mounting threads, 4-40UNC, for 60 mm cage systems. A central slide recess requires removal of the MTC-SM2E tube protection cover before placing a slide. Side clamp plates can move to opposing symmetric mounting holes. After prolonged use, a tool can adjust the U-shaped opening in the clamp-plate sleeve to restore clamping. Four corners carry 4 captive M3 mounting screws. Three threaded set screws precisely adjust level. Ensure these do not protrude below the holder during installation, to avoid damaging the platform or sample.

Save to Favorites